双鲸资讯
行业资讯当前位置：网站首页 > 新闻中心
压滤机停机后怎么办
压滤机停机后放着就可以了吗，其实没有这么简单，苏东化工提醒，停机后还要做好以下的后续操作，才能确保设备下一次的正常使用。
1、当压滤机设备停止运行的时候，最基本的工作就是确定设备中不在有过滤液，意思就是指设备中不能残次任何的过滤液，因为静止状态的过滤液，在设备中慢慢的风干，沉积下来，会形成一个一个的坚硬固体，这样不仅阻塞设备的重要部分，而且可能会让压滤机下次重启时，不能正常的工作，严重的话造成压滤机炸裂。因此必须将所用的过滤液从设备中清洗出来，防止它们在设备中风干或者发生化学变化。
2、压滤机的滤布一旦使用过后就一定必须保存滤布的湿润状态，因为现在一旦滤布和压滤机配合使用过，过滤液和设备强大的压力，都能让滤布发生微妙的变化，这样的滤布就没能再经受得住干燥考验了。因为滤布过干就会造成滤布纤维的缩小，这样滤布在拦截固体颗粒的质量上都会严重的改变，就会严重的影响压滤机的工作质量，也会让滤布更加的容易破损，所以停机后还要做好滤布的保护工作。
3、压滤机设备停止运行后一定要防止液压站进入水，不然会引起油的变质腐败，所以在停机后要做好液压站的密封保护工作。
停机工作不可马虎，直接影响着设备的使用寿命和下一次的工作效率，大家不能忽视后续的操作，对停机后的操作要给予和维护保养同等的重视。
The filter press can be put down after the shutdown, in fact, it is not so simple, Sudong chemical reminds, after the shutdown to do the following following operation, to ensure the normal use of the next equipment.
1, when the filter press equipment stops running, the most basic work is to determine that there is no filtrate in the equipment, meaning that the filter can not be residual in the equipment, because the static filter, slowly drying in the equipment, will form a hard solid, so that not only a solid solid is formed, so it is not only blocked. The important part of the equipment may also make the filter press fail to work properly when it is restarted next time. Therefore, the filtrate used must be cleaned from the equipment to prevent them from drying or chemical changes in the equipment.
2. Once the filter cloth is used, it must keep the wet state of the filter cloth, because once the filter and filter press are used together, the filter fluid and the powerful pressure of the equipment can make a subtle change in the filter cloth, and the filter cloth can not withstand the drying test again. As the filter cloth is dry, the filter fabric will be reduced, so the filter cloth will be seriously changed in the quality of the intercepting solid particles. It will seriously affect the quality of the filter press and make the filter cloth more easily damaged, so the filter cloth should be well protected after the shutdown.
3, the pressure filter equipment must prevent the hydraulic station from entering water, otherwise it will cause oil deterioration and corruption, so it is necessary to do a good job of sealing and protecting the hydraulic station after the shutdown.
Stop work is not so careless, directly affecting the service life of the equipment and the efficiency of the next work, we can not ignore the follow-up operation, the operation after the shutdown should be given the same attention to the maintenance and maintenance.